Powering ON/OFF
40
- ENGLISH
Basic Operation
Powering up the projector
When using an optional lens, install a projection lens
before switch on the projector. (
Remove the projection lens cover from the lens.
Connect the supplied power cable.
1 )
(AC220 V-240V 50Hz/60 Hz)
Press the [ | ] marked side of the
2 )
MAIN POWER switch to turn on the
power.
The POWER indicator lamp on the projector will
flash in red. After a short period, the indicator will
illuminate and the projector will enter standby
mode.
Press POWER ON ( | ).
3 )
[Power indicator] lamp illuminates in green and
soon the image is projected on the screen.
Note
If the projector is powered up at about 0 °C, a warm-up
z
period of approximately 5 minutes may be necessary to
start projection. <TEMP> indicator lamp lights up during
the warm-up period. When the warm-up is completed,
<TEMP> indicator lamp turns off and the image is
projected on the screen.
If the temperature of the operating environment is low
z
and warm-up takes more than 5 minutes, the projector
will judge that a problem has occurred and the power
will be turned off automatically. If this happens, increase
the temperature around the projector so that it is 0 °C or
higher, and then turn on the MAIN POWER switch and
the POWER ON ( | ) switch once more.
With [ECO] setting in [Standby mode]
z
switch on the projector, projection will start about 10
seconds late.
If the filter is not installed, the power is turned off
z
automatically after 10 minutes.
If projection was stopped last time by using the DIRECT
z
POWER OFF function, it can be started by setting the
MAIN POWER switch to the “ I ” (ON) position.
Making adjustment and
selection
It is recommended that the images are projected
continuously for at least 30 minutes before the focus
is adjusted.
Press <FOCUS> button, roughly
4 )
adjust the focus of the lens.
Select and set the projection scheme
5 )
of [INSTALLATION] and [COOLING
CONDITION] settings in [PROJECTOR
SETUP] menu.
Select the input signal by pressing
6 )
<INPUT SELECT> button (<RGB1>,
<RGB2>, <DVI-D/HDMI>, <VIDEO>
<S-VIDEO>, <SDI>).
(SDI: PT-DZ110XE/ PT-DS100XE only)
Adjust the tilt of the main unit in front
7 )
and rear or right and left.
Press <SHIFT> button to adjust the
8 )
position of the projection.
Press <AUTO SETUP> button if the
9 )
input signal is RGB signal.
Zoom the lens so the image fills the
10)
screen.
Readjust the focus.
11)
Readjust the zoom so that the image
12)
size fits in the screen.
2)
1)
7)
6)
9)
3)
5)
4)
8), 10), 11), 12)
9)
3)
5)
4), 11)
8)
6)
10), 12)
Summary of Contents for PT-DS100XE ( )
Page 130: ......
