English
English
17
16
After use
1. After ironing, place the iron on the heat-insulation pad
correctly, and then press and hold the power button for
about two seconds. When the product shuts down and all
indicators turn off, remove the power plug.
2. Take out the water tank and pour out the remaining water.
3. Install the water tank back to the power base and clean
residual water from where the water tank is installed.
4. Store the product in a safe place.
Cleaning
Notes:
a. After use, remove the power plug and leave the
product to cool down for more than 60 minutes before
any cleaning or maintenance.
b. Never use such cleaning products as the thinner,
cleanser and volatile solvent to wash the product.
Otherwise, the product may be damaged.
•
Cleaning the main body
For stubborn stains, use a soft cloth dipped with neutral
detergent to clean the surface of the main body.
•
Cleaning the soleplate surface
If glue or the like sticks to the soleplate surface, wipe it with a
wet cloth.
•
Cleaning steam vents
If scale appears on steam vents, remove the scale with a
wooden or bamboo toothpick and then wipe the soleplate with
a wet cloth.
•
Descaling
(Please perform the operation in a place
convenient for drainage)
•
For
NI-GT200
only: When the product has output steam for
up to 100 minutes accumulatively.
•
For
NI-GT500
only: When the product has been used for
up to 3,100 minutes accumulatively.
The descaling indicator will turn on,
indicating that accumulated scale
and other impurities in the
product need to be cleared.
Please follow the steps below
for descaling:
1. Disconnect the power supply and wait (for more than 60
minutes) until the product has fully cooled down.
2. Take out the water tank.
Descaling
indicator
4.2 For
NI-GT200
only:
1
Connect the power supply and press the power
button. The power indicator turns on. Press the steam
switching button to set the steam level and rotate the
temperature selector to align the desired level with
the thermostat indicator (See the section “Fabric and
ironing recommendations”). The steam level indicator
starts flashing and the thermostat indicator turns on.
2
Wait about one minute until the thermostat indicator turns
off, which indicates that the soleplate finishes heating.
About three minutes later, the steam level indicator
becomes steady on from flashing, which indicates that
the power base finishes heating. Then, you can press the
steam button to use steam for ironing.
∙
Do not press the steam button when the level set by
the temperature selector is outside the steam area and
the steam level indicator are still blinking. Otherwise,
water may leak from the soleplate.
•
Steam boost
When the enhanced steam level is set, if you press the steam
button twice in one second, steam boost will be generated in a
short time (about 2 seconds).
•
Automatic shut-off
When the product is not operated within 10 minutes or the
product uses only dry ironing continuously for 10 minutes, the
product will be automatically powered off.
To restart the product, press the power button again.
Notes:
a. During use, a few drops of water and steam may be
ejected from the soleplate at the same time. This is
normal.
b. Do not touch the soleplate before it has fully cooled
down.
c. Do not iron clothes that you are wearing.
d. Do not allow the soleplate surface to get close to
yourself or others.
e. Do not use steam when the iron is rested on the power
base in case of scalding.
f. During use, a large amount of steam will be ejected
when the steam button is first pressed and later the
amount of steam will slowly decrease and tend to be
flat. If a large amount of steam is needed, please put
the iron back to the power base and heat it for about
15 seconds.
NI-GT500 series-01 EN.indd 10
2021/8/20 14:34:25
