Panasonic NA-D106X1, Service Manual

Page: 49 / 68

49
NA-D106X1
4 I • Water supply
check
• Wash with warm
water check
• Drainage check
8 Panel display : "Wash""Rinse" and "Dry" blinks, LED
display indicate "8" and count down by one minute unit.
• Locks the Lid and supplies the water up to the set
level ( 70 mm).
Then performs warm water Wash for 6 minutes
followed by drainage.
Cooling fan is on.
*1.The water supply will continued maximum 8
minutes. Even if not complete within this 8 minutes
the job switch to warm water Wash mode.
*2.If the water level is less than 15mm during warm
water Wash, the heater does not turn On.
*3.If water drainage cannot be completed after 6
minutes from drain operation start, the operation is
finished automatically.
• If hot water heater is On condition, "Water"
temperature display shows Cold, 30°C,40°C and
60°C illuminate.
5 F • Setting the
correction data for
phase shifting
using the motor's
rotation sensor.
• Initializing the data
for the laundry
amount sensor.
F Make sure the empty inside the dram.
Panel display : "Wash" and "Dry" blinks, LED display
indicate "F".
Locks the Lid.
• Pressing "Rinse" button, the drum rotates slowly
right and left for approx. 15 seconds.
(If the service check F had switch from service
check d1, automatically start the drum rotation. )
During this operation, detecting correction data for
phase shifting with the motor's rotation sensor and
memorized.
• Then it performs the normal laundry-amount
detection.
After this detection, standard value have
memorized.
And then automatically Power Off.
• If controller have malfunction, LED display indicate
"H05".
6 G1 • LED display
showing the last
10 errors detected.
E1 Panel display : "Wash" and "Spin" blinks.
• Initially LED display shows "E1".
Each time "Rinse" button is pressed, the display
changes in following order:
Once, Latest error

Twice, 2 times before

3
time, 3 times before

.......

10 time, 10 times
before

11 time, "E1"(initial display).
Even if the same error occurs repeatedly, all error
records are displayed.
The contents are displayed alternately by a letter (U
or H) and an error number in the same way as Error
Display.
• The order of error occurrence shows "Water
Temperature" display by using binary number.
7 G2 • LED display
showing the last
3 errors detected
details.
E2 Panel display : "Wash" and "Spin" blinks.
• Initially LED display shows "E2".
• Each time "Rinse" button is pressed, the display
changes in following order:
Once, Latest error

Twice, 2 times before

3
time, 3 times before

4 times, "E2"(initial display).
However if the same error occurs repeatedly, it can
be display only initially occurred error.
The contents are displayed alternately by a letter (U
or H) and an error number in the same way as Error
Display.
• The order of error occurrence shows "Water
Temperature" display by using binary number.
Number of
times "Wash"
button is
pressed
Check
process
Checking contents LED display indication Operation contents