Panasonic NA-D106X1, Service Manual

Page: 26 / 68

26
NA-D106X1
2. Remove the Top mark C.
(Remove the hooks (both sides). Push down the Top
mark C rearward to remove. In the direction of an arrow)
8.1.3. Replacement of Top board
1. Remove the Cap A (one each for the left and right).
2. Remove 2 bottom Cap A screws, 2 bottom Top mark C
screws, 4 bottom Dry filter screws and 6 rear Top board
screws, and then remove the Top board.
*When the Leveler is replaced, remove the Top board as
described in the procedure above, and then disengage
the hooks on the back side to replace.
8.2. Lid sash, Lead wire cover,
Controller (Display side),
Door and Window cover
8.2.1. Replacement of Lid sash
1. Open the Door and disengage the hook on the Lid sash
with the slotted screwdriver, etc., and slide the Lid sash
upward to remove (Same procedure on both sides).
* While pushing the hook, slide the Lid sash upward to
remove. The hook on the Lid hinge U is located inside the
area where the removed Lead wire cover was.
Assemble in reverse order of disassembly.