Message
Cause and Solution
Connection will be closed in
n
seconds.
Press "YES" to continue.
Note
•
The message first
appears when one
minute remains and
"60"
is displayed for
n
. Then, the
remaining time starts
to decrease.
•
The time set for
"Call Limit time"
has one minute remaining
→
If you select
"Yes"
, you can extend the call limit time for the amount
set for
"Call Limit time"
. If you select
"No"
, the call is disconnected.
Unable to connect to network.
(XXXX XXXX)
Note
•
An error code
(consisting of
numerals) is
displayed in "XXXX
XXXX".
•
The LAN cable is not connected properly, and therefore you cannot
make a video conference call.
→
Check that the LAN cable is connected to the unit properly. Try making
a call again, after confirming that the IP address, SIP user name, etc.,
is displayed on the Home screen. If transmission still fails, make a note
of the error code and contact your dealer.
Note
•
If transmission fails due to the LAN cable not being connected
properly, it may take up to 10 minutes before the IP address, SIP
user name, etc., is displayed and video conference calls can be
made after reconnecting the LAN cable.
Disconnected.
•
When connecting to an MCU or non-Panasonic video conference
system, the video conference call was disconnected.
→
When connecting to an MCU or non-Panasonic video conference
system, some operations may not function as expected, depending on
the device used by the other party. In this case, contact your dealer.
•
When connecting to an MCU or non-Panasonic video conference
system, the video conference call was disconnected for an unknown
reason.
→
Wait a while and then try making the video conference call again. If
video conference calls get disconnected repeatedly, contact your
dealer.
Call failed due to insufficient
bandwidth setting on called
site.
•
The other party’s maximum bandwidth is set to a value that cannot
support 3-party/4-party video conference calls.
→
Ask the other party to change their maximum bandwidth setting.
Feature is not available with
current connection.
•
The other party cannot display the computer’s screen because their
display does not support the selected resolution.
→
Change the resolution setting to a resolution that is supported by the
other party.
→
Contact your network administrator.
•
Tone signals could not be sent because the other party’s device does
not support tone signals.
→
Ask the other party to check their configuration.
134
User Manual
Additional Information
Summary of Contents for KX-VC300CN
Page 141: ...User Manual 141 Notes ...