Panasonic KX-TVS120, Installation Manual

Page: 310 / 436

SYSTEM ADMINISTRATOR'S GUIDE
310 Installation Manual
To program the following 10 Parameters in the next table, use the Special Commands and Dial
Codes listed below. You can set up to 12 digits for each parameter.
D: Disconnecting
F: Hook Flash
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
X: Extension dialing
A: Answer
1-9, 0, , #: Dial Codes
N/A Not available
— Not needed
Table 78
Parameter Value Range
(Default)
Description/Function
Integration
Mode 1. None
2. Inband
3. DPT
(DPT)
Specifies the method of integrating the VPS with the
PBX.
1. None—Both PBX and VPS work independently,
without accessing information concerning the status
of the other.
2. Inband—The PBX sends touchtone codes to the VPS
to indicate the state of the call (busy, answered,
disconnect, etc.). Inband Integration improves the
VPS performance because call state recognition is
faster than with standard call progress tone detection.
The PBX code for each call state must be set in the
Inband Signaling Parameters. If PBX type is set to a
KX-T series telephone system, the Inband Signaling
Parameters will automatically default to the proper
codes. This is available with any of the following
Panasonic KX-T series telephone systems: T1232,
TA series, T96, T336, TD816, TD1232, TA1232,
TD500, and TD308.
3. DPT—The VPS communicates with the PBX via the
DPT interface. This is available with any of the
following Panasonic KX-T series telephone systems:
TD816, TD1232, TA1232, TD500, and TD308.