4.2 Programming the IP Proprietary Telephone
36
Information about IP Proprietary Telephones
When Assigning IP Addresses to IP-PTs Without Using a DHCP Server
If you are not using a DHCP server on the network, you will have to set an IP address and subnet mask
address to the IP-PT, in addition to the PBX IP address. If necessary, also enter the IP address of the default
gateway.
Follow the procedure below for all IP-PTs on the network, using appropriate IP addressing information.
If you need to set VLAN parameters, follow the procedure described in "4.2.2 Setting the VLAN Parameters"
after assigning the IP addresses without ending programming.
IP-PTs with a multiline display (e.g., KX-NT136)
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid IP address range: "0.0.0.0" to "255.255.255.255"
*3
Valid IP address range: "1.0.0.0" to "223.255.255.255"
Select "Network".
ENTER
Select "Disable"
for DHCP setting.
ENTER
IP Address*
1
Select "Subnet Mask".
ENTER
Select "Default Gateway".
ENTER
ENTER
Subnet Mask Address*
2
ENTER
Default Gateway Address*
3
ENTER
Return to the
Menu screen.
Select "PBX".
PBX IP Address*
1
ENTER
ENTER
To set the IP address of the IP-PT
To set the subnet mask address
To set the default gateway address (if required)
To enter the IP address of the IP-EXT card (PBX IP Address)
Select "IP Address".
To the VLAN settings
Press "STORE".
STORE
The IP-PT will reboot
and establish connection
to the network.
To end programming
To set VLAN parameters
OR
To start programming
Press "SETUP" when it is displayed.
SETUP
Supply power to the IP-PT.
Summary of Contents for KX-TDA50
Page 3: ...Information about IP Proprietary Telephones 3 Section 1 Introduction...
Page 11: ...Information about IP Proprietary Telephones 11 Section 2 Guidance for VoIP Installation...
Page 30: ...3 3 Connecting to the LAN 30 Information about IP Proprietary Telephones...
Page 43: ...Information about IP Proprietary Telephones 43 Appendix A Troubleshooting...