![background image](http://html1.mh-extra.com/html/panasonic/kx-tda50/kx-tda50_manual_3638306029.webp)
3.3 Connecting to the LAN
Information about IP Proprietary Telephones
29
Connecting an AC Adaptor to an IP-PT
IP-PTs comply with the IEEE 802.3af Power-over-Ethernet (PoE) standard. If PoE is available on your
network, the IP-PT can receive the necessary power supply from the network through the network cable. In
this case, no AC adaptor is needed for the IP-PT.
However, if PoE is not available, you will need to connect an AC adaptor to the IP-PT.
Notes
•
Only use the dedicated AC adaptor for your IP-PT.
•
Make sure to connect the AC adaptor firmly to the IP-PT parallel to the nub near the connector.
Then, pass the cord through the hook as indicated in the illustration below.
Connecting a PC to an IP-PT (except KX-NT265)
You can connect a PC to an IP-PT by using the IP-PT's secondary port. In this case, only a single port from
the LAN's network interface (switching hub) is required to connect both the IP-PT and PC to the LAN.
Notes
•
Use an Ethernet straight cable with an RJ45 connector to connect a PC to the IP-PT. The cable
should be a 100BASE-TX CAT 5 (Category 5) or higher cable.
•
Only a PC can be connected to the secondary port of an IP-PT. Other IP-PTs, or network devices
such as routers or switching hubs, cannot be connected.
•
Generally, it is recommended that you connect no more than one PC to the secondary port of each
IP-PT.
AC Adaptor Cord
To Wall Socket
Nub
Hook
Ethernet Straight Cable
To a PC
PC
Summary of Contents for KX-TDA50
Page 3: ...Information about IP Proprietary Telephones 3 Section 1 Introduction...
Page 11: ...Information about IP Proprietary Telephones 11 Section 2 Guidance for VoIP Installation...
Page 30: ...3 3 Connecting to the LAN 30 Information about IP Proprietary Telephones...
Page 43: ...Information about IP Proprietary Telephones 43 Appendix A Troubleshooting...