4.1 Programming the IP-EXT Card
32
Information about IP Proprietary Telephones
4.1
Programming the IP-EXT Card
4.1.1
Assigning the IP Addressing Information
When an IP-EXT card is placed on the LAN for the first time, it is necessary to assign IP addressing
information to the card. This is done by using the Maintenance Console (KX-TDA50: KX-TDA50
Maintenance Console; KX-TDA100/KX-TDA200: KX-TDA Maintenance Console; KX-TDA600: KX-TDA600
Maintenance Console).
Notes
•
It is assumed that you have already installed the Maintenance Console on your PC.
•
The programming procedure and screen shots shown in this manual are based on the KX-TDA600
Maintenance Console.
•
The contents and design of the software are subject to change without notice.
•
Screen shots reprinted with permission from Microsoft Corporation.
1.
Start the Maintenance Console from the Start menu.
2.
"Information before programming" appears.
a.
Carefully read this important additional information,
which includes updates to this and other manuals.
b.
Click [OK] to close this window.
3.
Enter the Installer Level Programmer Code (default:
INSTALLER
).
4.
a.
Click the check box to connect to the Hybrid IP-PBX.
b.
Enter the system password for installer (default:
1234
).
c.
Select "USB", then click [OK].
The programme menu appears.
5.
a.
Under
Configuration
, click
Slot
.
b.
Move the mouse pointer over the IP-EXT card. A
menu will be shown under the mouse pointer.
c.
Click
OUS
to set the card to out-of-service status.
d.
Move the mouse pointer over the IP-EXT card, then
click
Card Property
.
Summary of Contents for KX-TDA50
Page 3: ...Information about IP Proprietary Telephones 3 Section 1 Introduction...
Page 11: ...Information about IP Proprietary Telephones 11 Section 2 Guidance for VoIP Installation...
Page 30: ...3 3 Connecting to the LAN 30 Information about IP Proprietary Telephones...
Page 43: ...Information about IP Proprietary Telephones 43 Appendix A Troubleshooting...