64
KX-FP701ME
11.1.3. Service Function Table
Code
Function
Set Value
Effective
Range
Default
Remarks
501
Pause time set
X 100 msec
001~600
030
----------
503
Dial speed select
1: 10 pps
2: 20 pps
1, 2
1
----------
514
Bell detection time
X 100 msec
1~9
6
----------
520
CED frequency select
1:2100 Hz
2:1100 Hz
1, 2
1
See Symptom/Countermeasure Table for long distance
and international calls in
The unit can copy, but can-
not either transmit/receive long distance or interna-
tional communications
(P.92).
521
International mode select
1:ON 2:OFF
1, 2
1
See Symptom/Countermeasure Table for long distance
and international calls in
The unit can copy, but can-
not either transmit/receive long distance or interna-
tional communications
(P.92).
522
Auto standby select
1:ON 2:OFF
1, 2
1
The resolution reverts to the default when transmission
is complete.
523
Receive equalizer select
1: 0 km
2: 1.8 km
3: 3.6 km
4: 7.2 km
1~4
1
When the telephone station is far from the unit or recep-
tion cannot be performed correctly, adjust accordingly.
524
Transmission equalizer select
1: 0 km
2: 1.8 km
3: 3.6 km
4: 7.2 km
1~4
1
When the telephone station is far from the unit or trans-
mission cannot be performed correctly, adjust accord-
ingly.
544
Document feed position adjustment
value set
1~9 mm
1~9
5
When the ADF function is in correct, adjust the feed
position.
550
Memory clear
See
Memory Clear Specification
(P.66).
551
ROM check
See
Test Mode
(P.60).
552
DTMF single tone test
1:ON 2:OFF
1, 2
2
See
Test Mode
(P.60).
553
Monitor on FAX communication
select
1:OFF
2:PHASE B
3:ALL
1~3
1
Sets whether to monitor the line signal with the unit's
speaker during FAX communication or not.
554
Modem test
See
Test Mode
(P.60).
555
Scan check
See
Test Mode
(P.60).
556
Motor test
0
See
Test Mode
(P.60).
557
LED test
See
Test Mode
(P.60).
558
LCD test
See
Test Mode
(P.60).
559
Document jam detection select
1:ON 2:OFF
1, 2
1
Sets whether or not to detect a paper jam. If a docu-
ment with a length longer than 600 mm is copied or
transmitted, the unit stops copying or transmitting as a
paper jamming because a document over 600 mm is
not normal. In the factory, transmitting or copying a doc-
ument longer than 600 mm is done as an aging test. In
this case, OFF is selected.
561
KEY test
See
Test Mode
(P.60).
567
T0 timer
X second
001~255
046
Sets a higher value when the response from the other
party needs more time during automatic FAX transmis-
sion.
570
BREAK % select
1:61% 2:67%
1, 2
1
Sets the % break of pulse dialing according PBX.
571
ITS auto redial time set
X number of
times
00~99
00
Selects the number of times that ITS is redialed (not
including the first dial).
572
ITS auto redial line disconnection
time set
X second
001~999
065
Sets the interval of ITS redialing.
573
Remote turn-on ring number set
X number of
rings
00~99
10
Sets the number of rings before the unit starts to
receive a document in the TEL mode.
590
FAX auto redial time set
X number of
times
00~99
02
Selects the number of redial times during FAX commu-
nication (not including the first dial).
591
FAX auto redial time disconnection
time set
X second
001~999
065
Sets the FAX redial interval during FAX communication.
592
CNG transmit select
1:OFF
2:ALL
3:AUTO
1~3
2
Lets you select the CNG output during FAX transmis-
sion. ALL: CNG is output at phase A. AUTO: CNG id
output only when automatic dialing is performed. OFF:
CNG id not output at phase A. Refer to
Sometime
there is a transmit problem
(P.89).
Summary of Contents for KX-FP701ME
