Panasonic HYBRID IP-PBX KX-TDA100, Features Manual

Page: 235 / 380

1.25 Administrative Information Output Features
Feature Guide 235
• The PBX waits for a preprogrammed time period ( Call Duration Count Starting Time for
LCOT [208]) between the end of dialling and start of the SMDR timer for outgoing trunk
calls. When the PBX has sent out all dialled digits to the telephone company and this timer
expires, the PBX starts counting the call. A display PT shows the elapsed time of the call.
The starting time and the total duration of the call are recorded on SMDR.
If the reverse signal detection has been set (
1.5.4.5 Reverse Circuit), the PBX will start
counting the call after detecting the reverse signal from the telephone company regardless
of the above timer.
• Serial Interface (RS-232C) Parameters
The following communication parameters can be assigned for the Serial Interface (RS-
232C) port (
RS-232C Parameter—New Line Code [800], RS-232C Parameter—Baud
Rate [800], RS-232C Parameter—Word Length [800], RS-232C Parameter—Parity Bit
[800], RS-232C Parameter—Stop Bit Length [800]).
a)
New Line Code: Select the code for the PC or printer. If the PC or printer
automatically feeds lines with carriage return, select "
CR.
" If not, select "
CR+LF.
"
b)
Baud Rate: A baud rate code indicates the data transmission speed from the PBX to
the PC or printer.
c)
Word Length: A word length code indicates how many bits compose a character.
d)
Parity Bit: A parity code indicates what type of parity is used to detect an error in the
string of bits composing a character. Make an appropriate selection depending on the
requirements of the PC or printer.
e)
Stop Bit Length: A stop bit code indicates the end of a bit string which composes a
character. Select an appropriate value depending on the requirements of the PC or
printer.
Installation Manual References
Installation Manual
<KX-TDA100/KX-TDA200>
2.11.1 Connection of Peripherals
<KX-TDA15/KX-TDA30>
6.10.1 Connection of Peripherals
Feature Guide References
1.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
1.1.1.4 Multiple Subscriber Number (MSN) Ringing Service
1.2.2.6 Log-in/Log-out
1.11.1 Call Transfer
1.16.6 Direct Inward System Access (DISA)
1.28.1 TIE Line Service