Panasonic HYBRID IP-PBX KX-TDA100, Features Manual

Page: 232 / 380

1.25 Administrative Information Output Features
232 Feature Guide
[Explanation]
The following table explains the SMDR contents which are based on the numbers in the
previous pattern examples. For the programmable items, refer to the following
[Programmable Items].
Number in
the
Pattern
Item Description
(1) Date Shows the date of the call.
(2) Time Shows the end time of a call as Hour/Minute/AM or PM.
(3) Ext
(Extension) Shows the extension number, floating extension number,
etc., which was engaged in the call.
Also shows the following codes:
Dxxx: Outgoing trunk call from a doorphone
(xxx=doorphone number) (
1.16.1 Doorphone Call)
Txxx: Outgoing trunk call by TIE line service (xxx=trunk
group number)
*xxx: Verified call (xxx=verified code) (
1.8.6 Verified
Code Entry)
(4) CO (Trunk) Shows the trunk number used for the call.
For patterns A and B, "00" will be shown for trunk
numbers over hundred.
(5) Dial Number [Trunk Call]
Outgoing Trunk Call
Shows the dialled telephone number.
Valid digits are as follows:
0 through 9, , #
P: Pause
F: EFA signal
=: A Host PBX Access code (
1.5.4.7 Host PBX Access
Code (Access Code to the Telephone Company from a
Host PBX))
. (dot): Secret dialling
X: Privacy dial
–: Transferred call
If the transfer destination extension enters some digits,
the entered digits will be added after "–".
Incoming Trunk Call
Shows <I> + the caller’s identification name/number.
It is also possible to show the DDI/DID/MSN call
information. In this case, <D> + DDI/DID/MSN
name/number is added before <I> .
[Outgoing Intercom Call]
Shows the dialled extension number followed by "EXT".
[Log-in/Log-out]
Shows the log-in or log-out status.
(6) Ring Shows the ring duration before answering a call in
Minutes/Seconds.