Panasonic GT703, User Manual

Page: 99 / 105

6.2 GT704 Specifications
6-11

Ethernet port
Item Specifications
Interface 100BASE-TX
／
10BASE-T
Baud rate 100Mbps/10Mbps automatic negotiation (Note 1)
Connector shape Plug-in phone jack (RJ-45) (Note 2)
Cable total length 100 m (500 m when using a repeater) (Note 3)
Communication cable UTP cable (Category 5)
LINK/ACT lamp
Light on: When linked
Blinking: During data reception.
(Note 1): Switching between different speeds is done automatically by auto negotiation function.
(Note 2): Take care of handling of the connector not to add an excessive static electricity on the metal part
(Note 3): The standards cite 100 m as the maximum, but noise resistance measures such as attaching a ferrite core
may be necessary in some cases, depending on the usage environment. Also, if the hub is positioned close to a
control board, we recommend using it at a distance of 10 m or less.
(Note 4): The LAN port is insulated from the internal circuit.
* When using it as tool port, the GT cannot communicate with multiple tools (PC) including USB port simultaneously.

SD memory card
Item Specifications
Support media (Note 1)
SD memory card, SDHC memory card
(The manufacturer that the operation check has done: Panasonic
Corporation)
Supported format standard
Conforms to SD standard
(Please format with format software for SD memory cards.)
(Note 1): Check the usable temperature range of a SD memory card to be used before use.
Cautions on handling a SD memory card
The data saved in the SD memory card may be lost in the following cases. We assume no
responsibility whatsoever for the lost of saved data.
1) When a user or third party used the SD memory card incorrectly.
2) When the SD memory card was affected by any static electricity or electrical noise.
3) When the SD memory card was removed or the power supply of the GT unit was turned off
while data was being read, written or deleted to/from the SD memory card.
* It is recommended to save important data in another media for backup.