3.
Insert/Remove a disc.
To insert
Set the disc with the label side up and press the center of the disc until it clicks in place.
To remove
Press on the center spindle (C) and carefully lift up the edge of the disc.
4.
Close the tray.
Do not press the eject button (A).
N O T E
n
To remove a disc when the computer is powered off, insert a pin of 1.3 {±0.05} mm in diameters into the emergency hole (D). (When
the diameter of the pin is smaller than this, insert the pin slightly downward.) Pushing it to the end allows the tray to come out.
n
For AutoPlay CD/DVD/BD:
If an AutoPlay CD/DVD/BD does not start after the computer resumes from sleep or hibernation, remove the disc from the drive and
then reinsert it after waiting 15 seconds.
An AutoPlay CD/DVD/BD may start during file access depending on the status of the disc.
n
When playing back motion video from a disc, playback may not be smooth in some conditions.
Power-saving mode
If the optical disc drive is not accessed for 30 seconds, the drive motor will automatically be shut down to reduce the power consumption. When the optical
disc drive is accessed again, the drive motor is turned on. In this case, reading of the disc data will take approximately 30 seconds.
Movie Disc Playback
Installing PowerDVD
PowerDVD is a software application for DVD/BD playback. Install “PowerDVD” using “DVD Drive Utility Disc” or “BD Drive Utility Disc”.
1.
Sign in to Windows as an administrator.
2.
Set “DVD Drive Utility Disc” or “BD Drive Utility Disc” in the drive.
3.
At the [AutoPlay] message, click [Run SETUPUTIL.EXE].
