ENGLISH - 15
Installation (ET-WBC100) (continued)
2)
Pass the commercially available hex head bolt (M10) through the commercially available spring
washer (M10) and flat washer (M10), and the loop at the end of the wire rope, and then tighten it to the
anchor. (Fig.3)
z
When installing to a wooden structure, pass the loop at the end of the wire rope through the suspending
bolt and firmly fix the suspending bolt to the wall. (Fig.4)
Wire rope
Flat washer
Hex head bolt
Spring washer
z
When installing to a wooden structure
Wire rope
Hex nut
Spring washer
Flat washer
Fig.3
Fig.4
Attention
z
Purchase the commercially available anchoring nut or curled plug, hex head bolt, suspending bolt, flat washer and spring washer.
Attaching the covers
1) Attach the arm cover to the arm. (Fig.1)
z
Align the two protrusions on the inside of the arm cover with the two holes on the bottom of the arm. Push
the arm cover upwards so that it covers the end of the arm.
2)
Attach the left and right mount covers to the wall mount bracket. (Fig.2)
z
When attaching the mount covers, make sure the arrow marks on the mount covers are on the upper
side.
z
If the arm has been located at a height position more than +10 mm away from the factory default position,
interchange the left and right mount covers and make sure the arrow marks are on the lower side.
Fig.1
Fig.2
Note
z
It is recommended to install the arm cover after completing adjustments.
z
The wire rope is not shown in the illustrations.
