ENGLISH - 11
Attaching the projector drop-prevention kit
Install the drop-prevention wire rope to the projector (sold separately).
<For
PT-CMZ50>
1) Place the projector upside down on a soft cloth. (Fig.1)
2)
Retract the adjustable feet. (Fig.1)
z
Rotate the adjustable feet in clockwise to retract them.
3) Secure one end of the supplied wire rope to the A part on the projector by using a supplied captive
washer screw (M6 x 16) and a supplied flat washer (M6). (Fig.2)
z
Choose from the two wire ropes according to the distance (L2) from the back surface of the projector to
the wall surface.
If L2 is between 0 mm and 150 mm: Use the wire rope of 660 mm.
If L2 is between 150 mm (exclusive) ~ 270 mm: Use the wire rope of 750 mm.
Adjustable feet
Wire rope
Captive washer screw
Flat washer
Wire rope
Captive washer screw
Flat washer
A
Fig.1
Fig.2
A
Captive washer screw
(M6 × 16)
Flat washer (M6)
Wire rope
A
Attention
z
Be sure to use the supplied wire rope.
Installing the projector mount bracket kit to the projector
Install the projector mount bracket kit to the projector (sold separately) by following the procedure below.
<For
PT-CMZ50>
1) Pass the wire rope through the hole of the projector mount bracket kit. (Fig.1)
2) Secure the projector mount bracket kit to the bottom of the projector using the 4 supplied captive
washer screws (M6 × 16). (Fig.2)
Captive washer screw
Wire rope
Wire rope
Projector mount bracket
Fig.1
Fig.2
Installation (ET-WBC100) (continued)
