12 - ENGLISH
Installation (ET-WBC100) (continued)
Installing the wall mount bracket to the wall
1)
Temporarily paste the template sheet to the installation position determined according to “Installation
dimensions” (
x
page 7). (Fig.1)
z
Align the vertical line of “Image Center” on the template sheet to the center position of the screen.
2)
Select two from the four screw hole positions (Fig.2) used for temporary fixing of the wall mount
bracket for optimum balance. Drive commercially available M8 screws into the selected positions.
z
Leave at least 2 mm (3/32") - 4 mm (5/32") of space between the wall and the screw head so that the wall
mount bracket can be placed between them. The plate thickness of the wall mount bracket is 2 mm (3/32").
3)
Select a total of at least eight screw hole positions (at least one from each of the eight fixing locations
circled as shown in Fig.3).
H1
H2
L5
Fig.1
Fig.2
Fig.3
Wall mount bracket center →
← Image center
For M8
For M6
4) Install the wall mount bracket to the wall.
z
When installing to a wooden wall (Fig.4)
i)
Drill holes for M6 at all screw hole positions (at least 8 positions) selected in Step
3)
on the wall.
z
If the wall where the bolts are attached is not of sufficient strength, make the necessary
reinforcements to ensure a safe installation.
ii) Remove the template sheet.
iii) Place the wall mount bracket onto the two M8 screws installed on the wall in Step
2)
.
iv) Secure the wall mount bracket to the wall by tightening M6 bolts to all holes drilled in Step
i)
.
z
When installing to a concrete wall (Fig.5)
i) Attach the anchoring nuts or curled plugs for M6 to all screw hole positions (at least 8 positions)
selected in Step
3)
.
z
When installing anchoring nuts or curled plugs, strictly adhere to the installation instructions specified
by the manufacturer so that they will not loosen in the concrete structure or be dislodged from the
intended positions.
z
If the concrete wall is not of sufficient strength, reinforce it using steel or wood.
ii) Remove the template sheet.
iii) Place the wall mount bracket onto the two M8 screws installed on the wall in Step
2)
.
iv) Secure the wall mount bracket to the wall by tightening M6 bolts to all anchoring nuts or curled plugs
installed in Sep
i)
.
