4 - ENGLISH
Product description (ET-WBC100)
This is a wall mount bracket (Model No.: ET-WBC100) for installing the projector to a wall.
■
Applicable projectors
PT-CMZ50
Note
z
In this manual, the suffixes at the end of the model numbers are omitted.
z
Models other than those listed above may also be supported. Check the operating instructions of your projector or the following website.
https://panasonic.net/cns/projector/
■
Structural components
Parts name
Form (number of parts)
Applications
Wall mount bracket
× 1
This wall mount bracket is installed to the wall to
support the entire product.
In addition to forward/backward and vertical slide
adjustment, it allows vertical and horizontal tilt
adjustment and horizontal swing adjustment of the
projector.
Mount cover
Mount cover (L)
× 1
Mount cover (R)
× 1
These are attached to the wall mount bracket.
Projector mount
bracket kit
× 1
This is used to install the projector to the wall
mount bracket. It consists of a projector mount
bracket and a connecting plate.
It allows horizontal slide adjustment of the
projector.
Screws
Screw with captive washer (M6×16)
× 4
Used to secure the projector mount bracket kit to
the projector.
Flanged screw (M4×10)
× 4
Used to secure the projector mount bracket kit to
the wall mount bracket.
Projector drop-
prevention kit
Screw with captive washer (M6×16)
× 1
Prevents the projector from falling.
Use one of the two wire ropes.
Wire rope
[3.0 mm (1/8") wire diameter, 750 mm (29-17/32")
length]
× 1
Wire rope
[3.0 mm (1/8") wire diameter, 660 mm (25-31/32")
length]
× 1
Flat washer (M6)
× 1
