80
RQT8853
Cannot operate the TV or Set
Top Box with the unit’s remote
control.
Change the manufacturer code on the remote control.
68
Select TV or Set Top Box mode on the remote control.
68
Cannot operate the DVD.
Press [DRIVE SELECT] to select the DVD dri
v
e when operating
DVDs or CDs.
– Make sure the TV is on the correct channel or input mode.
7
Cannot operate the VHS.
Press [DRIVE SELECT] to select the VHS dri
v
e when operating
VHS cassettes.
–Make sure the TV is on the correct channel or input mode.
7
The remote control doesn’t work.
The remote control code is wrong. Change to the correct code.
78
The batteries are depleted. Replace them with new ones.
5
Point the remote control at the remote control sensor on the main unit.
5
Remo
v
e obstacles between the remote control and main unit.
−
Remo
v
e dust from the transmission window and the unit’s sensor.
−
Colored glass may obstruct the signal reception/transmission.
−
Don’t place the signal sensor in direct sunlight or in areas that may
be subject to sun exposure.
−
It may be necessary to set the code on the remote control again
after changing the batteries.
78
It may be necessary to set the manufacturer code again after
changing the batteries.
68
The unit is on but cannot be
operated.
Some operations are prohibited by the disc.
−
The unit is warm (“U59” appears on the unit’s display).
W
ait until
“U59” disappears.
−
One of the unit’s safety de
v
ices may ha
v
e been acti
v
ated.
Reset the unit as follows:
Press [
/I PO
W
ER] on the main unit to switch to off.
If the unit doesn’t switch to off, reset the unit (
¼
78, “To restore the
unit if it freezes”).
−
“U88” is displayed and the disc
cannot be ejected.
The unit is carrying out the reco
v
ery process. Do the following to
eject the disc:
(1) Press [
/I PO
W
ER] on the main unit to switch to off.
If the unit doesn’t switch to off, reset the unit (
¼
78, “To restore
the unit if it freezes”).
(2)
W
hile the unit is off, press and hold [
] and [CH
] on the main
unit at the same time for about 5 seconds. (Ejection may take
extra time depending on discs.) The disc may be defecti
v
e. Try
another disc.
−
Cannot eject a disc.
The unit is recording.
−
The unit may ha
v
e a problem. Eject the disc as in (2) abo
v
e.
−
Startup is slow.
Startup takes time in the following situations:
– A disc other than a DVD-RAM is inserted.
– The clock is not set.
– Immediately after a power failure or the AC power supply cord is
connected.
–
W
hen the unit is connected with an HDMI cable.
−
A password screen appears and
you are unable to
v
iew or record.
If the unit starts recei
v
ing a broadcast with the set rating information,
a password screen appears and you will be unable to
v
iew or record.
Enter your password to continue.
52
Time is incorrect after using
Auto Clock Setting.
Try again. If the time is still incorrect, set the clock manually.
48, 66
General Issues
Operation
Page
Troubleshooting Guide
M5821.indb 80
M5821.indb 80
2007/02/26 16:38:39
2007/02/26 16:38:39
