Smooth Operator Configuration Note (77200)
Panasonic DBS
C o n f i d e n t i a l
P a g e 5
The above information is provided by Octel Communications Corporation as a guide.
See disclaimer on page 1
O c t e l C o m m u n i c a t i o n s
1. Pick up the receiver or press the ON/OFF key.
2. Press PROG.
3. Dial #95.
4. Enter the DID/DNIS Answer code required by the Smooth Operator (1 to
6 digits).
5. Press HOLD.
6. Press the ON/OFF key.
The ON/OFF LED goes off.
To delete a DID/DNIS Answer Code:
1. Pick up the receiver or press the ON/OFF key.
2. Press PROG.
3. Dial #95.
4. Press HOLD.
5. Press the ON/OFF key.
The ON/OFF LED goes
off
Multiple DID/DNIS
Use this address to enable or disable Multiple DID for analog trunks, or
Multiple DID and DNIS for T1 trunks. By default, Multiple DID/DNIS is
disabled.
Note: We recommend that this feature remain disabled.
With Multiple DID/DNIS enabled, one DID or DNIS number can be
assigned to multiple extensions, which will simultaneously ring when an
outside caller dials the DID or DNIS number.
FF1 2# 1# 32# (0 or 1)#
Ç
0=Disables Multiple DID/DNIS ringing.
1=Enables Multiple DID/DNIS ringing.
DID/DNIS to a Smooth Operator Mailbox
This address determines whether (and how many) final digits of a
DID/DNIS phone number are transmitted to Smooth Operator, in cases
where the DID/DNIS trunk is assigned to ring directly to Smooth Operator
(not to a DBS extension phone). This address allows DID/DNIS calls to be
routed to a Smooth Operator Mailbox system that is not connected to a
physical extension.
To implement this feature, assign the DID/DNIS trunks to ring at the
Smooth Operator system (using FF4 ring assignment addresses). Once
Smooth Operator answers, the DBS sends a DID/DNIS Answer Code that
signals the Smooth Operator system to open the appropriate mailbox, plus
the final DID/DNIS digits (if any) specified in this address.
FF1 2# 1# 36# (0, 1 or 2)#
Ç
0=No DID/DNIS digits are transmitted (only the Answer Code).
1=Answer Code, then final 4 DID/DNIS digits are transmitted.
2=Answer Code, then final 3 DID/DNIS digits are transmitted.
Software Version: CPC-B Version
4.0 or higher
Software Version: CPC-B
Version 6.0 or higher
