Qty
Diagram
Item
No.
34
CY-VMC7000U
25
E
N
G
L
I
S
H
Installation Guide
WARNING
This installation information is designed for experienced installers
and is not intended for non-technical individuals. It does not contain
warnings or cautions of potential dangers involved in attempting to
install this product.
Any attempt to install this product in a motor car by anyone other
than qualified installer could cause damage to the electrical system
and could result in serious personal injury or death.
❏
Overview
This product should be installed by a professional.
However, if you plan to install this product yourself,
your first step is to decide where to install it. The
instructions in these pages will guide you through
the remaining steps: (Please refer to the “WARN-
ING” statement above).
¡
Identify and label the car wires.
¡
Connect the car wires to the wires of the power
connector.
¡
Install the unit in the dashboard.
¡
Check the operation of the unit.
If you encounter problems, please consult your
nearest professional installer.
Caution: This unit operates with a 12 volt DC nega-
tive ground auto battery system only. Do not attempt
to use it in any other system. Doing so could cause
serious damage.
❏
Installation Hardware
Flange Nut (M6)
Mounting Spring
Trim Plate
q
1
w
Mounting Collar
1
e
2
t
Mounting Bolt (M5)
1
y
1
Washer Assembling Hex.Bolt
(M5 x 10 mm)
u
1
Washer Assembling Hex.Bolt
(M6 x 20 mm)
i
1
Rubber Pad
r
1
o
Rear Support Strap
1
!0
Binding-Head Screw
(M5 x 6 mm)
2
!1
Flat-Head Screw
(M5 x 6 mm)
4
Qty
Diagram
Item
No.
CY-VMC7000U
Reverse Extension Cord
Double-Faced Adhesive
Tape (for spacer)
Binding-Head Screw
(M4 x 3 mm)
!2
4
!3
Spacer
2
!4
1 set
!6
Power Connector
1
!7
1
Clip Connector
!8
1
Display Unit/Control Unit
Connecting Cord
!9
1
Velcro Tape
!5
2
@0
Double-Faced Adhesive
Tape (for speaker)
1
@1
Clamp
2
