VIDEO-CONT
REVERSE
SIDE BRAKE
BATTERY 5A
ACC
PRE-OUT
SPEAKER
!6
Power Connector
Ground Lead
To a clean, bare metallic
part of the car chassis
Battery Lead
To the car battery,
cont12V DC
Video Control Lead
To the Video Control lead of
the Panasonic car navigation
system (not available yet)
Power Lead
To ACC power, +12V DC
(Green / yellow stripe)
(Fuse 5A)
(Yellow)
(Red)
(Black)
(Bule / yellow stripe)
(Violet / white stripe)
(Resistor 220
Ω
)
Reverse Lead
When connecting the rear
view camera, use the reverse
lead. (
a
page 47)
Side Brake (Parking Brake)
Connection Lead
Be sure to wire the parking
brake for safety and preventing
accidents. (
a
page 46)
(Black)
(Black)
(Black / green stripe)
Speaker Lead
Pre-out Cord
(R) (Red)
(L) (White)
RGB Input Cord
To the RGB Connector of the Panasonic
car navigation system (not available yet)
!9
Display Unit / Control Unit Connecting Cord
REMOTE-OUT
CY-VMC7000U
Display Unit (Rear)
Use a Reverse Extension Cord
!7
if needed.
!
@
42
CY-VMC7000U
33
E
N
G
L
I
S
H
Electrical Connections
Cautions:
¡
This product is designed to operate off a 12 volt, negative ground battery system.
¡
To prevent damage to the unit, be sure to follow the connection diagram below.
¡
Remove approx. 1/4" (5mm) of protective covering from the ends of the leads before connecting.
¡
Do not insert the power connector into the unit until the wiring is completed.
¡
Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keep
cable terminals free from touching any metal parts.
¡
Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased when
the battery terminals are disconnected.
Wiring Diagram
No.
Item
Q'ty
!6
Power Connector
1
Supplied Hardware
!7
Reverse Extension
Cord
1
!8
Clip Connector
1
!9
Display Unit / Control
Unit Connecting Cord
1
