35
CY-VMC7000U
26
E
N
G
L
I
S
H
Before you begin installation, look for the items on
the right which are packed with your unit.
¡
Warranty Card …… Fill this out promptly.
¡
Panasonic Servicenter for Service Directory
…… Keep for future reference in case the product
needs servicing.
¡
Installation Hardware …… Needed for in-dash
installation
❏
Before Installation
Warning
¡
Do not install the monitor in a location which
obstructs driving, visibility or which is prohibited
by applicable laws and regulations. If the monitor
is installed in a location which obstructs forward
visibility or operation of the air bag or other safety
equipment or which interferes with operation of
the vehicle, it may cause an accident.
¡
Never use bolts or nuts from the vehicle's safety
devices for installation. If bolts or nuts from the
steering wheel, brakes or other safety devices are
used for installation of the monitor, it may cause
an accident.
¡
Attach the wires correctly. If the wiring is not cor-
rectly performed, it may cause a fire or an acci-
dent. In particular, be sure to run and secure the
lead wire so that it does not get tangled with a
screw or the moving portion of a seat rail.
¡
Use with 12 volt DC negative ground vehicle. This
unit is only for use with a 12 volt DC negative
ground vehicle. It cannot be used in large trucks
or diesel vehicles which are 24 volt DC vehicles. If
it is used in the wrong type of vehicle, it may
cause a fire or an accident.
Caution
¡
Use the specified fuse. Be sure to always use the
specified fuse. If a fuse other than the specified
fuse is used, it may cause a fire or an accident.
¡
Do not damage the cord by pinching or pulling it.
Do not pull or damage the cord. If the cord is not
treated properly, it will short out or be severed and
may cause a fire or an accident.
❏
Required Tools
You’ll need a screwdriver and the following:
❏
Dashboard Specifications
❏
Identify All Leads
The first step in installation is to identify all the car
wires you’ll use when hooking up your LCD monitor.
As you identify each wire, we suggest that you label
it using masking tape and a permanent marker. This
will help avoid confusion when making connections
later.
Note: Do not connect the power connector to the
display unit until you have made all connections. If
there are no plastic caps on the hooking wires, insu-
late all exposed leads with electrical tape until you
are ready to use them. Identify the leads in the fol-
lowing order.
12 V DC
Test Bulb
Electrical
Tape
Side-Cut
Pliers
THICKNESS
MIN. 3/16" (4.75 mm)
MAX. 7/32" (5.56 mm)
2-3/32" (53 mm)
7-5/32" (182 mm)
