Panasonic CS-E9PD3EA, Service Manual

Page: 44 / 112

44
Remote Controller Installation
1 Remove the remote controller lower case.
(Insert a flat-tipped screw driver or similar tool
2 to 3 mm into one of the gaps at the bottom
of the case, and twist to open. Refer to the
illustration at right.)
Be careful not to damage the lower case.
2 Do not remove the protective tape which is
affixed to the upper case circuit board when
remove the remote controller lower case.
3 Secure the lower case to an outlet box or wall.
Refer to (A) or (B) instructions below
depending on your choice of cable installation.
4 Be sure to use only the screws provided.
5 Do not over tighten the screws, as it may
result in damage to the lower case.
6 Connect the indoor unit and the remote controller as shown in the illustration at below.
7 Insert firmly the connector of remote controller cable to connector at control box of indoor unit.
8 Fix the green wire from remote controller cable to the grounding location provided.
A. IF REMOTE CONTROLLER CABLE IS EMBEDDED
1 Embed an outlet box (JIS C 8336) into the wall. Outlet box maybe purchased separately. Medium size
square outlet box (obtain locally) Part No. DS3744 (Panasonic Co., Ltd.) or equivalent.
2 Secure the remote controller lower case to the outlet box with the two accessory screws . Make sure that
the lower case is flat against the wall at this time, with no bending.
3 Pass the remote controller cable into the box.
4 Route the remote controller cable inside the lower case through rear feeding-out direction.
5 Insert firmly the connector of remote controller cable to connector (CON1) in the upper case circuit board.
(Refer to the illustration at below.)
6 Secure the remote controller upper case to the lower case with the tabs provided.
When the wall is hollow, please be sure to use the sleeve for remote controller cable to prevent dangers caused by mice biting the cable.