Panasonic CS-E9PD3EA, Service Manual

Page: 43 / 112

43
PREPARING TO INSTALL THE INDDOR UNIT

Fit the drain hose insulation around the drain hose as shown in the diagram beside.

Attach the discharge chamber. (  ) (10 screws)

Cut out the intake cut-out portions at the unit rear panel using a cutter or other tools to make openings.

Remove the two screws at the rear edge of the unit top panel and attach the intake chamber. (

) (8 screws)
Securing the Hanging Bolts
Switching the High State Switch (SW2)

To increase the air volume, open the control box and on the control board, switch the FAN switch (SW2) to “HI”.

See the diagram for “Connecting the Indoor/Outdoor Connection Cable”.
Installation into the Ceiling

Attach the nuts and washers to the hanging bolts, then lift up and hook the main unit onto the hanging fixtures.

Check if the unit is leveled using a level or a vinyl hose filled partially with water.