Operating Instructions
Wireless remote control (optional accessory)
This unit can be operated by remote control using a wireless
remote control (model number: AW-RM50G) purchased separately.
Check out the following points before using the wireless remote
control.
z
Point the wireless remote control at the unit’s wireless
remote control signal light-sensing area (front panel or
back panel), and operate it within a range of 10 meters
(32.8 ft) from these areas.
z
Refer to <Layout of wireless remote control signal
light-sensing areas> on the right.
z
The signal sensing distance is reduced if the angle at
which the wireless remote control signals are sensed is
increased.
The light-sensing sensitivity is reduced to about one-half when the
wireless remote control is pointed at an angle of 40 degrees from
each position in front of a wireless remote control signal light-sensing
area (front panel or back panel).
If the remote control is operated from the behind the unit, it may be
either difficult or impossible to perform the desired operations.
z
If the unit is installed near fluorescent lights, plasma
monitors or other such products or if the unit is
exposed to sunlight, the effects of the light may make it
impossible for the unit to be operated using the wireless
remote control.
Be sure to follow the steps below for installation and use.
•
Take steps to ensure that the wireless remote control signal light-
sensing area will not be exposed to the light from fluorescent lights,
plasma monitors or other such products or from the sun.
• Install the unit away from fluorescent lights, plasma monitors and
other such products.
z
For about 10 minutes even after the batteries have been
removed from the wireless remote control, the selection
of the operation to be performed (the <CAM1>, <CAM2>,
<CAM3> or <CAM4> button which was pressed last) will
remain stored in the memory.
When a longer period of time elapses, however, the
selection is reset to the status established when the
<CAM1> button was pressed.
<Layout of wireless remote control signal light-sensing areas>
<NOTE>
•
The arrows in the figure below show the light-sensing directions in
which the wireless remote control signals travel.
Wireless remote
control signal light-
sensing area (back
panel, 1 place)
Wireless remote
control signal light-
sensing area (front
panel, 2 places)
•
Top view
•
Rear panel view
Approx. 45°
Approx. 45°
46
