9
How to turn the power on and off
(continued)
p
w
Turning the power off
When performing the operations
using the wireless remote control
1
Press one of the [CAM1] to [CAM4] buttons on
the wireless remote control to select the unit.
2
Press the [ON/STANDBY] button on the
wireless remote control for 2 seconds.
The unit’s power is turned off.
p
The unit’s status display lamp now lights up orange.
3
If a multiple number of units are used, repeat
steps
1
and
2
as required.
4
Set all the power switches of the units and
devices connected in the system to OFF.
p
When transferring to the STAND BY mode
(Status display lamp: Orange)
The pan/tilt position is stored in the memory, and
the pan/tilt unit is moved so that it points backwards.
p
When transferring to the POWER ON mode
(Status display lamp: Green (after the initial setting
operation is completed))
The pan/tilt unit is moved to the position which was
stored in the memory when the transition to the
STAND BY mode was made.
p
POWER ON preset
The pan/tilt unit is moved to the setting, which was
established immediately prior to the transition to the
STAND BY mode, when the power has been turned
on.
p
If the power is turned off without transferring to the
STAND BY mode, the pan/tilt unit position will not
be stored in the memory or reflected in the POWER
ON preset. The zoom position is stored using the
setting established immediately before the power is
turned off.
Notes
When performing the operations using the controller
When the AW‑RP655 or AW‑RP555 is connected:
1
Set the [OPERATE] switch on the controller to
OFF.
The power of all the cameras (including the unit)
connected to the controller is turned off.
p
The unit’s status display lamp now lights up orange.
2
Set all the power switches of the units and
devices connected in the system to OFF.
p
When transferring to the STAND BY mode
(Status display lamp: Orange)
The pan/tilt position is stored in the memory, and
the pan/tilt unit is moved so that it points backwards.
p
When transferring to the POWER ON mode
(Status display lamp: Green (after the initial setting
operation is completed))
The pan/tilt unit is moved to the position which was
stored in the memory when the transition to the
STAND BY mode was made.
p
POWER ON preset
The pan/tilt unit is moved to the setting, which was
established immediately prior to the transition to the
STAND BY mode, when the power has been turned
on.
p
If the power is turned off without transferring to the
STAND BY mode, the pan/tilt unit position will not
be stored in the memory or reflected in the POWER
ON preset. The zoom position is stored using the
setting established immediately before the power is
turned off.
Notes
For further details, refer to the Operating Instructions of the
controller.
When the AW‑RP50 is connected:
Refer to the Operating Instructions of the controller.
