Panasonic AJ-D610WBp, Service Manual

Page: 98 / 363

ELE-42
10. VIDEO MAIN
10-1. AUDIO_VCO Adjustment
BOARD
VIDEO _MAIN, RF
TP
TP1[DET] (RF)
ADJUST EVR
INPUT Internal Color Bar
MODE EE
TAPE -
M. EQ. Oscilloscope
SPEC. A = B+/-5%
Menu Setting
1. While pressing the keys
[SHIFT], [+], and [-] on
the operation panel and set the [MENU] switch to
SET.
2. Set the menu as shown below.
PAGE: SERVICE ADJ 1/2.
ECU CONNECT : EVR
EVR Setting
3. Set the EVR as shown below.
COM:[02] DATA:[80] ADR:[04]
4. Connect a scope to TP1 and adjust EVR so that
the width A and B are the same by
[
← ← ← ←
]/[
→ → → →
].
5. Close the Menu.
10-2. Y/C Timing Confirmation
BOARD VIDEO _MAIN
TP VIDEO OUT
ADJUST DESIGN MENU
INPUT -
MODE 25M / PLAY
TAPE
VFM3580KM (PULSE & BAR)
VFM3680KM (PULSE & BAR)
M. EQ. Oscilloscope
SPEC. A = Minimum Level (flat)
Menu Setting
1. While pressing the keys [SHIFT], [+], and [-] on
the operation panel and set the [MENU] switch to
SET.
2. Set the menu as shown below.
PAGE: REC (ASPECT)/PB/RET:
PB MODE : 25M
PAGE: DESIGN
LUMA DELAY
: 0/ 1/ 2/ 3
3. Playback an alignment tape (PULSE & BAR).
4. Connect a scope to the
VIDEO OUT and set
[DESIGN MENU] so that the level A is minimum.
5. Close the menu.
A
B
TRIG at this point
A
VIDEO OUT