– 81 –
Chapter 4 Adjustments and Settings for Recording — Viewfinder status display
Display item
Display details
NETWORK
5
[NETWORK]
Network type and operation status
[WLAN], [LAN], [OFF]
f
If the selected network is not operated, [ERROR] is displayed at the bottom.
6*
[STREAM]
Streaming mode and status display
f
[RTP]
: When RTP mode is selected
f
[HTTP]
: When HTTP mode is selected
f
[ERROR]
: Streaming cannot be activated
f
[INHIBIT]
: When the [STREAMING MODE] item of the menu is set to [INHIBIT]
7*
[ERROR] factor of [STREAM]
Display the factor why streaming is not activated
f
[!PROXY MODE]
: When proxy setting is not streaming-compatible format
f
[!PRE REC]
: When pre-recording function is turned on and proxy recording is set
* This is not displayed if the network function is not activated, or if the video encoder board (optional AG-YDX600G) is not installed.
Center marker display
The [MARKER] item on the setting menu [DISPLAY SETUP] screen is set to [ON].
@
@
NOTE
t
The center marker is displayed only in the viewfinder. It is not displayed in the video output and SDI output.
Safety zone display
The option selected at the [SAFETY ZONE] item on the setting menu [DISPLAY SETUP] screen is displayed.
[OFF]
Does not display.
[90%]
Displays the range that can be displayed in most household TVs.
[4:3]
Displays the position after the screen is adjusted by 4:3 aspect ratio.
[13:9]
Displays the position after the screen is adjusted by 13:9 aspect ratio.
[14:9]
Displays the position after the screen is adjusted by 14:9 aspect ratio.
@
@
NOTE
t
When the [SYSTEM MODE] item on the [SYSTEM SETUP] screen is set to [480-59.94i] and [576-50i], and the [ASPECT CONV] item is set
to [SIDE CROP] and [LETTER BOX], this is not displayed even by selecting [4:3], [13:9], or [14:9].
t
The center zone is displayed only in the viewfinder. It is not displayed in the video output and SDI output.
Zebra patterns display
The camera can display two types of zebra patterns.
When the ZEBRA switch of the viewfinder is set to on, the zebra pattern currently set in the menu is displayed on the viewfinder screen.
Zebra patterns can also be displayed in the video of the <MON OUT> terminal according to settings.
The level for displaying zebra patterns can be set on the setting menu [DISPLAY SETUP] screen.
Item
Setting value
Description of settings
[ZEBRA1 DETECT]
[50%] ... [70%] ... [109%]
Sets the level of zebra pattern 1 tilting to the right.
[ZEBRA2 DETECT]
[50%] ... [85%] ... [109%]
Sets the level of zebra pattern 2 tilting to the left.
[ZEBRA2]
[ON], [SPOT], [OFF]
Selects the type of [ZEBRA2].
Underlined settings are factory settings.
