13
Chapter
1 Applying Eff
ects to
Video and Sound
Adjusting Colors of Video
[COLOR EFFECTS]
The [COLOR EFFECTS] menu is used to make settings for
applying effects to the colors of video for each bus.
The color effects to video can be set including color
balance and brightness adjustment.
NOTE
The color effect and MONO (monochrome) effect cannot be
used at the same time. The color effect cannot be applied to
the video to which MONO has been applied as the video effect.
[COLOR EFFECTS] menu
The menu appears when the A/PROG COLOR EFFECTS or
B/PRESET COLOR EFFECTS button is pressed to turn on.
The color effects set currently are applied at the same time.
To display the menu without applying the effects, press
either COLOR EFFECTS button while holding down the
SHIFT key.
When the preview output is executed, switching is
automatically performed between video A and video B
according to the pressed button.
COLOR
0
0
128
128
0
Y SETUP Y GAIN
P
B
P
R
C GAIN
EVENT
ME TIME
PATTERN
INT
00
E
1:00
F
3001 BLUE
P
B
128
C GAIN 0
P
R
128
COLOR EFFECTS
CH A
Set [Y SETUP] (Y signal setup) in the range of [–128] to
[+127] using the rotary 1 control.
The factory default setting is [0].
Set [Y GAIN] (Y signal gain) in the range of [–128] to
[+127] using the rotary 2 control (0 dB=0).
The factory default setting is [0].
To adjust the color balance, adjust [PB] and [PR]. Use
the rotary 3 (for X direction) and rotary 4 (for Y direction)
controls or operate the joystick in the X and Y directions.
Set [C GAIN] (chroma gain) using the rotary 5 control or
rotary Z control.
At that time, the joystick, rotary Z control settings, and 3D
display area of the setting screen (
page Vol.1-20) shows
the P
B
, P
R
, and C GAIN values.
To set the color saturation to 0 temporarily
Press the CENTER button during operation of the [COLOR
EFFECTS] menu, the color saturation can be set to zero
temporarily.
NOTE
If the No. 221 or 222 (1068 or 1069) pattern is selected, the
•
MIX pattern with the color effects applied is set, the COLOR
EFFECT button is lighted, and the [COLOR EFFECTS] menu
appears.
No color effects can be applied to internal video.
•
Applying Effects to Video
[VIDEO EFFECTS]
The [VIDEO EFFECTS] menu is used to apply changes to
video or video switching effect for each bus.
Special video effects such as mosaic and paint can be set
in this menu.
NOTE
No video effects can be applied to internal video.
•
Only one choice can be made from multi-strobe, decay, trail,
•
and shadow. The effect selected last has priority, and the
previously selected effect is canceled.
Decay cannot be set to ON for both A/PROG and B/PRESET
•
at the same time. The setting made last has priority and the
other made earlier is turned OFF.
Only one choice can be made from multi-strobe and mosaic.
•
The effect selected last has priority, and the previously
selected effect is canceled.
[VIDEO EFFECTS] menu
The menu appears when the A/PROG VIDEO EFFECTS
or B/PRESET VIDEO EFFECTS button is pressed to turn
on. The video effects set currently are applied at the same
time.
To display the menu without applying the effects, press
either VIDEO EFFECTS button while holding down the
SHIFT key.
When the preview output is executed, switching is
automatically performed between video A and video B
according to the pressed button.
Adjusting Input Video
