Panametrics DigitalFlow GM868, Service Manual

Page: 32 / 72

Chapter 2. Error Codes and Screen Messages
22 DigitalFlow™ GM868 Service Manual
Log DONE, to inspect
hit any key
When in the LOG menu, this message indicates that the log is
complete. Hit any key to display the log.
Log hasn’t started! hit key
When in the LOG menu, this message indicates that the log has not
yet started.
OK, settling The measurement has not stabilized. Wait before taking a reading.
Outside limits, value rejected.
When in the CAL menu, this message indicates that the calibration
of the analog output is invalid. Hit any key to clear the message,
and the GM868 will default to the last valid calibration. The
message will also appear if there is no ammeter connected to the
analog output during calibration.
Overflow
The display value overflowed. Reduce the number of decimal
digits or change the units.
??P<L Enter L again.
The entered path length (P) is less than the axial dimension (L).
Enter a new value for L.
range is X.XX to X.XX
When in the User Program, this message indicates that the entered
number is unacceptable. Hit any key and enter a number within
the allowable range.
Review calibration
An option card error indicating a programming failure or a loss of
memory. Contact the factory.
Review parameters
An option card error indicating a programming failure or a loss of
memory. Contact the factory.
Staring time must exceed
current time
This message appears when in the LOG menu STD option. Enter a
start time that is later than the current time.
Write error.
An option card error indicating a programming failure or a loss of
memory. Contact the factory.
Table 2: Screen Messages(Continued)
Message Meaning