8
Palram Americas
• Drilling Holes in the Profiles
• Adding Profile Closures
Measure, mark and pre-drill 1/4" screw holes in each End Profile Base and Inner Profile Base.
• Follow the hole spacing guidelines below for rafter or purlin installation to match your roof support structure.
• Make sure all holes are centered along the notch in the middle of each Profile channel.
Fasten a Profile Closure to the TOP and BOTTOM end of every End Profile Base
and Inner Profile Base.
• The Profile Closure will prevent the Roof Panel from sliding off when the Roof Panel is being installed.
5
6
24" max
24" max
24" max
2"
2"
2" min
Overhang
PR
O
FI
LE
R
A
FTE
R
WALL
RAFTER INSTALLATION
PURLIN INSTALLATION
Measure distance
between purlins
center to center
PR
O
FI
LE
PURLIN
WALL
PURLIN
PURLIN
End Profile Base
Inner Profile Base
Before drilling holes, place the End Profile Base over a strip of wood.
This will protect the end of the drill bit as it penetrates the End Profile Base.
End Profile Closure
Inner Profile Closure
= H
O
LE
S/
FA
ST
EN
ING
P
O
IN
TS
BEFORE INSTALLATION
