Palram.com
17
• Installing End Profile Bases with UNCUT Roof Panels
IF YOU HAVE ALREADY INSTALLED CUT ROOF PANELS, SKIP TO PAGE 19.
END PROFILE BASES HAVE A DIFFERENT ORIENTATION WHEN USED WITH
UNCUT ROOF PANELS.
1
2
• Be sure the correct edge of the End Profile Base
is facing inward toward the roof.
• Center the profile in the middle of the rafter.
• Using the spacer bar at every hole, fasten
screws through the pre-drilled holes along the
first End Profile Base.
• Be sure the correct edge of the End Profile Base
is facing inward toward the roof.
• Center the profile in the middle of the rafter.
• Using the spacer bar at every hole, fasten
screws through the pre-drilled holes along the
second End Profile Base.
Fasten the first End Profile Base to the left edge of the roof.
Fasten the second End Profile Base to the right edge of the roof.
INSTALLATION
NOTE: PROFILE
CLOSURE NOT
SHOWN IN
DRAWING
NOTE: PROFILE
CLOSURE NOT
SHOWN IN
DRAWING
CORRECT PROFILE ORIENTATION
CORRECT PROFILE ORIENTATION
