HEATER BACK COVER KIT INSTALLATION
The heater back cover kit is supplied with the heater. The back cover kit attaches to the rear of the heater and the top
cover rear edge is located over the two back cover kit wall brackets (to locate and mount back cover kit wall brackets
refer to the installation instructions supplied with the flue kit).
Sideways and under floor installations require an Extra Wide Back Cover Kit (kit PWSK001) which is utilised instead
of the standard back cover kit supplied with the heater.
STANDARD BACK COVER KIT CONTENTS (Supplied with Heater)
Item
Description
Quantity
A
Top Cover
1
B
RH Side Cover
1
C
LH Side Cover
1
D
Wall Brackets
2
E
Wall Bracket Screws
2
F
Hexagon Bolt
4
G
Exhaust Connection Clamp
1
H
Air Intake Cable Tie
1
N/A
Control Panel Keys *
2
* PRS-250CN and PRS-250CL commercial models only.
EXTRA WIDE BACK COVER KIT CONTENTS (Kit PWSK001 – For Sideways & Underfloor Installations)
Item
Description
Quantity
A
Top Cover
1
B
RH Side Cover
1
C
LH Side Cover
1
D
Heater Side Replacement
Brackets
2
E
Screws 8g X 14
8
Note: Use wall brackets and wall bracket screws
from standard back cover kit supplied with heater.
STANDARD BACK COVER KIT INSTALLATION
Warnings:
Warning: Before installing the back cover kit, ensure the heaters exhaust tube and air intake hose are firmly
connected.
Warning: Ensure that nothing (including air intake hose) is in contact with metallic parts of the heaters exhaust
tube. Reposition telescopic exhaust tube insulating sock if required.
Procedure:
1.
Align LH side cover screw hole over hole in heater
lower bracket and insert cover location tab into heater
side slot.
2.
Fasten LH side cover to lower bracket with hexagon
bolt.
3.
Align RH side cover screw hole over hole in heater
lower bracket and insert cover location tab into heater
side slot.
4.
Fasten RH side cover to lower bracket with hexagon
bolt.
5.
Align top cover over top of LH & RH side covers and
the two wall brackets.
6.
Fasten top cover to side covers with hexagon bolts.
23
