Document #: 020-17475-00 Revision: E
Page #: 41 of 63
When failure mode is activated during a recipe run the job is paused automatically and
can be resumed upon failure reset. “Unscheduled Finish” is displayed with a time
stamp, run duration and name of the recipe after finishing the recipe run. To resume to
the Auto Mode screen press the OK button.
Aborting a Recipe
Supervisors and Maintenance user levels can abort running recipes. To abort a recipe
that is currently running, press and hold the
Abort
button. When a routine is aborted the
“Unscheduled Finish” screen with a time stamp, name of the recipe aborted and run
duration will open. To resume to the Manual Mode screen press the OK button.
Pausing and Resuming a Recipe
Supervisors and Maintenance user levels can pause and resume recipes. To a recipe
that is currently running, press and hold the
Pause
button. A blinking “Routine Paused”
status is displayed in the status bar. To resume the recipe from where it was paused,
press and hold the
Resume
button.
Editing a Recipe
Supervisors and maintenance user levels can edit a recipe’s instructions. To edit a
recipe, follow these steps:
1.
Press
Select
on the Automatic Mode screen. The Recipe Selector screen opens.
Use the arrow buttons at the top of the screen to scroll through the list of recipes until
you open the one you want to edit.
Press
Edit
. The Recipe Editor screen opens (Figure 49).
If needed, press the
Back
and
Next
buttons on the right side of the screen to scroll
through the list of instructions for that recipe.
Each recipe can contain up to 10 instructions
Set the parameters to use for a specific instruction.
Press
Pause
to set the length of time the LevMixer should pause for that
instruction. When the keypad opens, type the length of time to pause and
then press
Enter
.
Press
Run
to set the length of time the LevMixer should run for that instruction.
When the keypad opens, type the length of time to run the mixer and then
press
Enter
.
Press
Speed
to set the RPM set point at which the mixer should run for that
instruction. When the keypad opens, type the RPM set point and then press
Enter
.
2.
Press
Save
to save your changes to the recipe. To return to the Automatic Mode
screen without saving your changes to the recipe, press
Cancel
.
