Packard Bell EasyNote TK13BZ, Service Manual

Page: 61 / 216

System Utilities
2-9
NOTE:
NOTE
:
When prompted to enter password, three attempts are allowed before system halts.
Resetting BIOS password may require computer be returned to dealer.
Setting a Password
0
Perform the following to set user or supervisor passwords:
1. Use the

and

keys to highlight the
Set Supervisor Password
parameter and press
Enter . The
Set Supervisor Password
dialog box appears.
NOTE:
NOTE
:
To change an existing password, refer to Changing a Password .
Figure 2-4. Set Supervisor Password
2. Type a new password in the
Enter New Password
field. Passwords are not case
sensitive and the length must not exceed 12 alphanumeric characters (A-Z, a-z, 0-9).
Retype the password in the
Confirm New Password
field.
IMPORTANT
:
+
Use care when typing a password. Characters do not appear on the screen.
3. Press Enter . After setting the password, the computer sets the
User Password
parameter to
Set
.
NOTE: NOTE :
Password on Boot
must be set to
Enabled
to activate password feature.
4. Press F10 to save changes and exit BIOS Setup Utility .
Password on Boot
CAUTION:
!
If Power-on-Password authentication is
enabled, the BIOS password can only be
cleared by initiating the Crisis Disk Recovery
procedure. Refer to
Crisis Disk Recovery .
Shows if password is required during system boot
Disabled or
Enabled
Table 2-3. BIOS Security (Continued)
Parameter Description Option