Packard Bell EasyNote NS11HR, Service Manual

Page: 71 / 162

www.packardbell.com
65
Replacing the Bluetooth module
Tools you need to complete this task:
Screws removed during this task:
•
3 black M2.5×6 (bay cover)
•
1 black M2×3 (hard drive)
•
1 black M2.5×6 (optical drive)
•
9 black M2.5×6 (palm rest - base side) -
Indicated by A in step 8 of the “Replacing the palm rest module” procedure
on page 48
To replace the Bluetooth module:
1
Complete the steps in “Preparing the notebook” on page 37 .
2
Complete the steps in “Removing the battery” on page 38 .
3
Remove the hard drive by performing steps 3 and 4 of the “Replacing the
hard drive” procedure on page 41 .
4
Remove the optical drive by performing steps 3 and 4 of the “Replacing the
optical drive” procedure on page 46 .
5
Remove the palm rest by performing steps 8 – 13 of the “Replacing the palm
rest module” procedure on page 48 .
6
Disconnect the Bluetooth cable from its system board connector (1) , and then
detach the Bluetooth module (2) .
7
Place the new Bluetooth module on the system board and reconnect the
Bluetooth cable to its system board connector.
8
Reinstall the keyboard by performing steps 21 – 24 of the “Replacing the
keyboard” procedure on page 53 .
Phillips #0 screwdriver
Flat screwdriver or Non-marring plastic scribe