SECTION 4
OPERATION
68
4.6.3 GENERAL SETUP
GENERAL SETUP is used for UPC SETUP, LCD SETUP, UPC STATUS and POWER SOURCE
STATUS.
From any METER display (V/I, AMPS or POWER), press the
fn
key to enter SETUP MODE.
From the SETUP display, press
3
to enter GENERAL SETUP 1.
GENERAL SETUP 1: 4 POWER SOURCE STATUS
1 UPC SETUP 5 RANGE CONTROL
2 LCD SETUP 6 SLEW RATE SETUP
3 UPC STATUS 7 More Options
Press
7
to display these additional items:
GENERAL SETUP 2: 4
1 INITIAL VOLTAGE 5
2 KEYBOARD LOCK 6
3 TRANSIENT WFs 7
The following pages describe each menu item shown above.
4.6.3.1 UPC SETUP
UPC SETUP is used to select meter sense point, enable or disable Continuous Self Calibration (CSC),
set the Programmable Output Impedance (Option), set transition time and voltage and frequency limits.
From any METER display (V/I, AMPS or POWER), press the
fn
key to enter SETUP MODE.
From the SETUP display, press
3
to enter GENERAL SETUP 1.
From the GENERAL SETUP 1 display, press
1
to enter UPC SETUP.
UPC SETUP: SENSE=INT, CSC=OFF
PROG.Zo - Hit EDIT. TRANSITION TIME=0
FREQ. LIMITS MIN=45 MAX=5000
VOLTAGE LIMITS MIN=0 MAX=600
SENSE
:
INT
ernal or
EXT
ernal. This is the sense point for metering and CSC.
EXT
ernal uses the remote sense terminals on the rear panel of the Power
Source.
CSC
:
OFF
or
ON
. Continuous Self Calibration. If EXTernal SENSE is selected, CSC
may be used to compensate for output wiring losses and maintain accurate
program output voltage at the sense point which may be the load.
Summary of Contents for UPC-12
