7
300309-20
Surround Assembly and Installation
1) Lay part A, B and C face down on a flat non-marring
surface. Fasten together with 1/4" x 1/2" bolts and nuts
provided through holes at points “D” (Fig. #5 and 8).
2) Lift the surround assembly to the upright position and
make sure the front face is flat and even at the joints.
3) Assemble the three trim pieces using the enclosed
hardware. Slide part F into the back corners of the trim
and tighten screws. Ensure the mitred corners fit tightly
and evenly (Fig. #6).
4) Slide the assembled trim over the surround from the top
(Fig. #5).
5) Tighten the retaining screws at the bottom of each trim
side (Fig. #7).
Fig. # 5
Fig. # 6
Fig. # 8
6) On the stove, loosen the two bolts that fasten the ashlip
in place and remove. Place on a flat, stable surface to
avoid damage (Fig. #9).
Part B
Trim
Fig. # 7
Trim
Retaining
Screw
Part F
Part A
Part C
Part A
Trim
D
D
D
1/4" Nuts
Part C
1/4" x 1/2" Long Bolts
Fig. # 9
Summary of Contents for Pacific Wood Insert DESIGN-D
Page 17: ...17 300309 20 NOTES...
Page 18: ...18 300309 20 NOTES...
Page 19: ...19 300309 20 Label...
