17
TROUBLE
PROBABLE CAUSE
REMEDY
E
Winch runs hot.
1. Be certain the hydraulic system
temperature is not more than
200ºF (93ºC). Excessive hydraulic
oil temperatures may be caused
by:
A. Plugged heat exchanger (where
used).
B. Too low or too high oil level in
hydraulic reservoir.
C. Tractor hydraulic pump not operat-
ing efficiently.
2. Excessively worn or damaged
internal winch components.
Same as D1A.
A. Thoroughly clean exterior and flush
interior of heat exchanger.
B. Fill or drain reservoir to proper level.
C. Tractor low on horsepower or RPM.
Tune-up or adjust tractor engine for opti-
mum performance. See tractor service
manual for more information.
Check suction line for damage.
Pump worn or damaged. Inspect or
replace pump as needed. See tractor
service manual for more information.
A. Disassemble winch for inspection or
replacement of worn or defective compo-
nents.
TROUBLESHOOTING
If a winch exhibits any sign of erratic operation or
load-control difficulties (such as load creeping or
chattering), appropriate troubleshooting tests and
repairs must be performed immediately. Continued
operation under any of these conditions may result
in loss of load control, property damage, serious per-
sonal injury, or death.
!
WARNING
!
