83
Slide Rail Kits
If you are unable to locate clear instructions on installing your enclosure, please
contact Technical Support.
Enclosure Installation Prerequisites
To ensure proper installation and functionality of the Unified Storage System, please
observe the following warnings:
Cross check all components have been received against the “Unpacking List”. Contact your
vendor immediately if anything is missing
Install the enclosure as-is out of the packaging; install hard drives and optional
modules (FBM / super capacitor) after the enclosure has been mounted
Wear an anti-static wristband before and during the installation procedure
It is recommended to plug the system into two different power sources (e.g. into a
power outlet and another into a UPS)
Ensure the rack which the enclosure will be mounted onto has proper grounding and over-
current protection
Do not obstruct ventilation openings; provide 20cm of free space at the front and back of
the enclosure for air circulation; keep the ambient temperature below 35 degrees Celsius
Unpacking the System
Use the “Unpacking List” to cross check all components have been received. The basic
contents include one GUI CD pack, Quick Installation Guide and Unified Storage System
Installation Guide. For details on each slide rail kit contents, please refer to specific kit
installation details in this manual.
Component Installation Procedure
Please install components in the following order:
1.
Rackmount rails onto the enclosure / rack / cabinet
2.
Enclosure onto the slide rail and into the cabinet
3.
Hard drives into drive trays and then into the enclosure
4.
Drive trays (with or without hard drives) into the enclosure
5.
If super capacitor / FBM were purchased as an optional component, the controller must
be removed from the enclosure for installation.
NOTE
For detail procedures from step 3 and onwards, please refer to the earlier sections
in this hardware manual.
