SRM Operations Manual
33
Using The Telephone Interface |
Copyright © P Squared Ltd 2013
Use the RJ11 to BT Plug cable to connect the ‘Line’ socket on the SRM (Channel 9 rear panel) to the
BT analogue phone line socket on your wall.
Use the RJ11 to RJ11 cable to connect from the Handset socket on the SRM to the socket on your
handset (usually on the side, rear or bottom of the handset).
That is the basic setup complete. You can test your connections by listening to the receiver on the
phone handset, you should get a dial tone just like any other phone. If you can hear a dial tone then
it should all be connected correctly.
Using The Telephone Interface
Once connected, you can use the telephone interface on the SRM to route telephone calls through
the mixing desk with the phone call being routed by the TEL/Aux Channel ( channel 9) on the mixer.
