10
ASSEMBLY
Attaching Your Accessory
1. Choose the desired angle required for your application.
2. Position the perforated holes on the accessory over the
locating pins on the accessory drive spindle (6) of the
multi function head.
3. Ensure the accessory is sitting flat against the face of
the accessory drive spindle (6) (Fig. 3 & 4).
4. Place the accessory fixing washer (12) in alignment with
the inner hole of the accessory drive spindle (6).
Note:
Ensure the flat side of the accessory fixing washer (12)
is facing towards the accessory.
5. Insert the locking bolt (13) through the accessory
fixing washer (12) and into the accessory drive spindle
(6) of the Multi Function Tool. Hand tighten only.
6. Tighten the locking bolt (13) using the allen key (14) in
a clockwise direction (Fig. 5). Do not overtighten!
Removing Your Accessory
1. Loosen the locking bolt (13) using the allen key (14) in an anti-clockwise direction.
2. Remove the locking bolt (13) and the accessory fixing washer (12) from the Multi
Function Tool. Remove the accessory.
3. To re-attach an accessory, follow the instructions on “Attaching your accessory”.
Changing Sanding Paper
1. Align the sanding paper (11) to the hook & loop
sanding pad (8) and press firmly to hold in place. As
this product does not include a dust extraction system,
it is not critical that the holes in the sanding paper
lines up with the holes on the hook & loop sanding
pad (8).
2. To remove or change the sanding paper carefully
peel off the sanding paper from one of the triangle
ends (Fig. 6).
Fig. 3
Accessory Drive Spindle fixed
to the Multi Function Tool
Accessory locating pins
Fig. 6
Fig. 5
Fig. 4
Accessory
perforated
holes
Inner hole
