INSTALLING OR REMOVING THE BATTERY
10
!
Always ensure the forward/reverse lever (2) is in the lock position before
insertion or removal of the battery.
To Install the Battery
•
Holding the impact driver upright and picking up the
battery (4) in your free hand. Place your two fingers over
the battery release buttons (3) and insert the battery (4)
until it clicks into place. (See Fig. 2)
•
Do not use excessive force when inserting the battery (4).
If the battery (4) does not slide in easily, it is not being
inserted correctly. It is also possible that there could be
damage to the battery, battery terminals or drill.
To Remove the Battery
•
Depress the battery release buttons (3) on both sides of the handle and pull the
battery (4) down away from the tool.
Battery
The length of service from each charging cycle will depend on the type of work you
are doing. The batteries in this drill have been designed to provide maximum trouble
free life. However, like all batteries they will eventually wear out.
To obtain the longest battery life, we suggest the following:
•
Store and charge your batteries in a cool area. Temperatures above or below
normal room temperature will shorten battery life.
•
All batteries gradually lose their charge. The higher the temperature the quicker
they lose their charge.
Caution:
Charger does not automatically turn off when the battery is fully
charged. Please take care not to leave the tool on the charger for excessive
periods of time. Switch off the charger at mains when charging is complete.
Fig. 2
