INTRODUCTION
3
Congratulations on purchasing an Ozito 12V Lithium Ion
Cordless Impact Driver. We aim to provide quality tools at
an affordable price.
We hope you will enjoy using this tool for many years. Your
12V Lithium Ion Cordless Impact Driver LID-012 has been
designed for to drive and remove screws and to tighten and
loosen nuts and bolts quickly and efficiently and is intended
for DIY use only.
ELECTRICAL SAFETY
!
WARNING!
When using mains-powered tools, basic safety precautions,
including the following, should always be followed to reduce risk of fire,
electric shock, personal injury and material damage.
Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for future
reference.
Note:
The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.
This tool is double insulated in accordance with AS/NZS 60335-1;
therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by a qualified electrician or a
power tool repairer in order to avoid a hazard.
If operating a power tool in a damp location is unavoidable use a residual current
device (RCD) protected supply Use of an RCD reduces the risk of electric shock.
Note:
Double insulation does not take the place of normal safety precautions
when operating this tool. The insulation system is for added protection against
injury resulting from a possible electrical insulation failure within the tool.
!
