8
CHARGING THE LITHIUM ION BATTERY
The multi function tool has been shipped in a low charge condition, and requires
charging prior to use.
Initial Charging
1. Ensure that the charging cradle (16) is on a flat surface. Insert
the charging jack (17) into the charging cradle (16).
2. Plug the charging adaptor (15) into a power outlet.
3. Insert the battery (3) into the charging cradle (16) (Fig. 1). The
recess of the battery terminals will have a firm connection.
Upon proper contact the red and green light will illuminate on
the charging cradle (16).
4. To obtain optimum battery performance and life, charge the
batteries for 5-7 hours and use the tool until it runs down. Repeat this charge and
discharge process approximately 4-5 times.
Note:
If the light on the charging cradle (16) fails to come on:
•
Check the charging adaptor (15) is securely plugged into the wall outlet and is
switched on.
•
Check the charging jack (17) is securely connected to the charging cradle (16) socket.
•
Check the battery (3) is firmly seated onto the charging cradle (16).
Normal Charging
•
When the unit is on charge the red and green light will be on display.
•
Charging starts automatically. The battery (2) will take 3-5 hours to charge.
•
When the battery (2) is fully charged, the red light will go out, and only the green
light will be on display.
•
Remove the battery (2) from the charger after 5 hours.
Important Charging Notes
•
The charger adaptor (15) and battery (3) may become warm to touch while
charging. This is normal, and does not indicate a problem.
•
Use the charger at normal room temperature whenever possible. To prevent
overheating, do not cover the charger and do not charge the battery (3) in direct
sunlight or near heat sources.
NOTE:
If battery is flat and displays green charged LED, refer to thermal voltage
protection note below cooling maybe required.
Thermal voltage protection indication
In the event that the thermal or voltage protection circuit has been activated the
battery will cease to operate. This can happen when the tool has been used for
extended periods or worked hard with large drill bits or accessories.
If you place the battery on the charger the LED lights will give you the appearance that the
battery is fully charged. Leave the battery on the charger to charge for 3-5 hours.
The battery may take the full 5 hours to charge as the battery may need to cool down
or the protection circuit to be reset. This will then allow the charger to begin charging
the battery and resume normal operation.
Fig. 1
