13
OPERATION (cont.)
Changing the direction of rotation
•
The direction of rotation can be changed with the
forward/reverse selector (2). This is located above
the variable speed switch (5) (see Fig. 12).
•
To select the forward driving or tightening position, push the forward/reverse
selector (2) hard left.
•
To select the reverse driving or loosening position push the forward/reverse
selector (2) hard right.
•
The variable speed switch (5) can be locked off by pushing the forward/reverse
selector (2) into the middle of both forward and reverse positions.
WARNING!
Do not change direction of rotation unless the tool has
come to a complete stop.
Using the tool
Insert the correct driving bit or socket bit (with socket adaptor).
Before starting your job, always perform a test operation in a similar application using
scrap material.
When fastening screws sized M8 or smaller, take particular care to use light pressure
on the variable speed switch (5) for fear of damaging the fixture.
Hold the tool pointing straight in line with the fastener
and apply sufficient forward pressure to stop the bit
from slipping off the fastener (See Fig. 13).
Apply slight pressure to the variable speed switch (5) to
turn on the tool then increase the speed according to
the circumstances.
Do not apply torque for too long when tightening a screw
or nut or it will be damaged.
Fig. 13
Fig. 12
!
