Ozito DP-350, Instruction Manual

Page: 11 / 16

!!
10
ADJUSTMENTS
WARNING! Before making any adjustments, ensure the drill press is
disconnected from the mains power.
Adjusting the Table Height
1. Loosen the table support lock (23) (Fig. 14).
2. Set the desired table height and tighten
the table support lock (23) to secure the
table (11) in position (Fig. 15).
Adjusting the Table Angle
The table (11) can be adjusted up to 45° to
the left or right.
1. Loosen the table support angle bolt
(located below the table) by rotating
anti-clockwise using an 18mm spanner
or shifter (not supplied) (Fig. 16). Align
and set the desired angle.
2. Tighten the table support angle bolt by rotating in a clockwise direction to secure
the table (11) in position.
CAUTION: When the table is angled/tilted, ensure the workpiece is clamped to the table (11).
Installing and Removing Drill Bits
1. Using the chuck key (22), loosen the
jaws of the chuck (18) by rotating in an
anti-clockwise direction (Fig. 18).
2. Insert the drill bit fully into the 13mm
keyed chuck (18) (Fig. 19).
3. Whilst holding the drill bit in one hand rotate the top collar
of the 13mm keyed chuck (18) in a clockwise direction.
Ensure you tighten all 3 holes in the 13mm keyed chuck (18)
using the chuck key (22) to securely tighten the jaws and hold
the drill bit in position (Fig. 20).
Pre-setting the Drilling Depth
1. Loosen the depth indicator lock nuts (15) by turning in an anti-clockwise direction.
2. Ensure the drill bit is secure in the 13mm keyed chuck (18) and tightened correctly.
Lower the feed wheel handles (6) to the desired depth using the depth scale (24).
Fig. 14 Fig. 15
Fig. 16 Fig. 17
Fig. 18
Fig. 19
Fig. 20