OPERATION
12
1. Ensure the drill press is switched off and disconnected from the power supply.
2. Loosen the jaws of the 13mm keyed chuck (18) with the chuck key (22) by turning
in an anti-clockwise direction and insert the selected drill bit into the 13mm keyed
chuck (18) as far as it will go.
3. Ensure that the drill bit is centred in the 13mm keyed chuck (18) and tighten the
chuck jaws with the chuck key (22) in a clockwise direction. Tighten all three holes
to ensure the drill bit is secured evenly by each jaw.
4. Select your drilling depth and secure the depth indicator lock nuts (15) in position.
5. Adjust the table (11) to your desired position.
6. Slowly rotate the feed wheel handles (6) to bring the drill bit down towards the
table (11) and into your workpiece. After drilling a hole, release the feed wheel
handles (6) slowly to return the 13mm keyed chuck (18) to its original position.
Note:
Ensure the hole in the centre of the table (11) is aligned with the drill bit. If not
aligned, use the 4mm allen key (21) provided to loosen the head assembly (12) on the
column support (9) and re-align the head assembly (12). Re-tighten the 2 head lock
screws (4).
7. Continue the operation until the task is completed. When completed, switch the
drill press off by pressing the red (O) button on the switch (13).
WARNING!
Ensure the drill press is disconnected from the power supply
before performing any maintenance.
1. Ball bearings are packed with grease at the factory. No further lubrication of
bearings is required.
2. Lubricate all moving parts periodically. Wipe the column, table and base with an
oily cloth to minimise corrosion.
3. Keep air vents clean of dust and dirt.
4. Remove dust and dirt from the drill press regularly with a soft cloth, brush or
compressed air.
5. If the power cord is damaged, have it replaced by an
electrician or a power tool repairer.
6. Regularly check that all bolts, screws and nuts are securely
fixed as these could work loose during normal operation.
7. If the drive belt will not align with the pulleys. The pulleys
may be worn and need to be replaced. To remove the
pulleys, use the 3mm allen key (20) provided. Loosen in
an anti-clockwise direction (Fig. 26).
Note:
Ozito Industries will not be responsible for any damage or injuries caused by the
repair of the drill press by an unauthorised person or by mishandling of the drill press.
MAINTENANCE
Fig. 26
!!
Summary of Contents for DP-350
Page 1: ......
