8
ASSEMBLY
!!
WARNING!
During assembly ensure the drill press is disconnected from the
power supply.
1. Carefully remove contents from the packaging.
2. Select a firm, level surface on which to assemble the drill press.
3. Select the base (10) (Fig. 1) and align the column (8) over the large hole (Fig. 2).
Align the holes in the column support (9) with those in the base (10) and secure in
place using the 3 column support bolts (19), spring and flat washers (supplied) (Fig. 3).
Fit the spring washer over the bolt followed by the flat washer and using a 12mm
spanner or shifter (not supplied) securely tighten all 3 column support bolts (19).
4. Slide the table support (7) over the column (8). Using the
table support lock (23), secure the table (11) into the
desired position (Fig. 4).
5. Lift the head assembly (12) and slide it down onto the
column (8) as far as it will go. To secure in position install
the two head lock screws (4). Tighten using the 4mm
allen key (21), rotating in a clockwise direction (Fig. 5).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Summary of Contents for DP-350
Page 1: ......
